• Heavier shank & thread diameters than most "standard" roofing fasteners.
• Deep buttress thread for high pullout resistance.
• Extra sharp drill point for quick installation in new or reroof applications.
• Available with #3 phillips truss head.

The OMG Standard RoofGrip Drill Point Fastener must penetrate steel decks a minimum of 3/4-in., wood plank decks a minimum of 1-in. and 1/2-in. through the underside for plywood decks.  Using a screw gun,* drive the fastener until a slight depression is seen around the plate. 

Note:  Care must be taken not to overdrive the fastener and fracture the skin of the insulation.  Fastener must be tight enough so that the plate doesn't turn. 

For steel decks, Factory Mutual requires that the fastener penetrates the deck at the top flute. 

To speed installation, this fastener can be used with the AccuTrac® System and is also available pre-assembled.   See AccuTrac or ASAP®.

OMG CR-10 corrosion resistant coating exhibits less than 15% red rust after 30 Kesternich cycles.  CR-10 coating exceeds F.M. Approval Standard 4470.

Use appropriate steel or plastic plates, depending upon the application.  See Plates section.  *For best installation result, use a variable speed 0-2500 rpm screw gun. See Accessories section.