• Diamond point allows easier installation and less chance of hole damage.
• Split bulb exerts pressure on walls of hole, producing remarkable holding power.
• Strongest hammer-in fastener available.
• Typical pullout values in cured concrete (3000 psi) are over 800 lbs. A pullout test is recommended.
• The OMG CD-10 is Factory Mutual and Dade County approved.

Predrill a 7/32" hole using a carbide drill bit. The fastener is then installed with a 2 lb. short handle sledge hammer. Minimum fastener embedment into the deck should be 1". The predrilled hole must be a minimum of 1/2" deeper than fastener embedment.

Note: Prior to job start, contact OMG to perform a pullout test to determine the pullout values.  Also, care must be taken not to overdrive the fastener causing subsequent damage to the insulation facer.

OMG CR-10 corrosion resistant coating exhibits less than 15% red rust after 30 Kesternich cycles. CR-10 coating exceeds F.M. Approval Standard 4470.

Appropriate steel or plastic plates, depending on application. See Plates section. Use a 7/32" carbide tip SDS or straight shank drill bit.